StarTech.com VGA2TV2WAY, Instruction Manual, Page: 7 / 11

5
setting.
4. When you are satisfied with your changes, press
MENU
to
activate the setting.
5. You can continue to adjust other settings, or select Exit from
the OSD menus until the OSD disappears.
The following options can be adjusted from the OSD menu
system:
Input Setup
(Adjusts the sampling rate)
Clock
Phase
Output Setup
(Adjusts the output resolution/refresh)
Resolution-Refresh Rate (Hz.)
Picture Adj.
(Adjusts picture quality/appearance)
Contrast
Bright(ness)
Color
Red
Green
Blue
Reset
H V Adjust
(Adjusts the position of the image on the display)
H Pos(ition)
V Pos(ition)
OSD Adjust
(Adjusts the position of the OSD menu on the display)
H Pos(ition)
V Pos(ition)
Auto Adjust
(Resets to factory default settings when selected)
System Information
(Displays the current settings of the video scaler)
INPUT [Resolution-Refresh Rate (Hz.)]
OUTPUT [Resolution-Refresh Rate (Hz.)]
The video converter will store your changes until it is reset to its default settings.
NOTES:
• The
System Information
OSD menu does not allow you to modify any settings and
shows the current state of the video converter settings.
• The
Output Setup
menu allows you to adjust the output resolution and frequency of
the video converter. For more information about the resolution and refresh setting
supported by the device and correlating pixel counts for various settings (i.e. “SVGA”),
please see the “Specifications” section of the manual. You should exercise caution in
adjusting this setting, since a setting that exceeds the capabilities of your display could
cause damage in some situations. Consult the documentation for your display to
determine if the setting you wish to use is supported.
• Selecting
Auto Adjust
from the OSD menu is the same as using the reset procedure on
the front panel.
Input set up
Output set up
Picture Adjust
HV Adjust
OSD Adjust
System Information
Auto Adjust
Exit