StarTech.com VGA2TV2WAY, Instruction Manual, Page: 6 / 11

4
or similar) on the HDTV source. (This is the same set of connectors used by the
previous display that you removed in step 1, if applicable.)
5. Connect the VGA connection from the VGA display to the
PC/HDTV
connection on
the front panel of the video converter.
7. Connect the AC power adapter to a suitable wall outlet. Connect the opposite end to
the
DC 12V
connector on the rear panel of the unit.
8. Power on both the HDTV signal source and the VGA display.
Using the Menu Options
The video converter uses an intuitive on-screen display (OSD) system that allows you to
fine-tune the video output to the display you are using.
By default, the video converter selects an output setting of XGA (1024 x 768 pixels, 60
Hz). If the video setting you select from the OSD menu system exceeds the capabilities
of the display you are using, you can reset the video converter to the default setting by
using the following button combination on the front panel:
Press
+
and
-
at the same time to force the unit to XGA, 60 Hz.
1. After you have connected the video source and display to the video converter using
the directions in the previous section, power on both the device and the display.
2. The display should show a bright-blue screen. Be sure that the video source is sending
a video signal to the video converter for testing purposes.
4. Once the correct a signal source is detected, the device will display the image source
on the screen. Depending on the requirements of the display, you may need to adjust
the output settings on the video scaler for best image quality. See the instructions
below for more information.
Using the OSD
The video converter automatically interprets the input resolution and scales it to the
output resolution selected in the menu system. While the default settings will provide
an image, the video scaler offers several settings that will allow you to adjust the output
signal for the best possible result.
NOTE:
Changing the settings below may cause the signal to become unusable if the
settings you select are incompatible with your display. Should this occur, repeat the
steps outlined in the section above to reset the video scaler back to a compatible setting.
To activate the menu system, press the
MENU
key on the front of the video scaler once.
The OSD will display the available option on the left-hand side of the screen. To
navigate the menu system:
1. Use the
+
and
-
keys on the front of the video converter to move
between options.
2. Use the
MENU
key to select an item to adjust or display a
sub-menu.
3. Once an item is selected, use the
+
and
-
keys to adjust the