Instruction Manual
5
Operation
After following the previous Installation instructions, the ST10CSU2A can be used in
“Charge” or “Sync” operating modes.
Charge Mode
Connected tablet devices will charge. Sync capabilities are disabled and you cannot
sync your tablet device with your host computer.
1. Toggle/push the Charge and Sync Button inside the ST10CSU2A, ensure the button
is in the “up” position to enable charge mode (sync is then disabled).
Sync Mode
Connected tablet devices will sync with your host computer.
1. Toggle/push the Charge and Sync Button inside the ST10CSU2A, ensure the button
is in the “down” position to enable sync mode.
Note:
Most devices will still provide some level of charge capabilities to your
connected tablet devices while in sync mode, however, some devices cannot
simultaneously charge and sync. It is recommended you switch back to charge mode
once your syncing tasks are completed to continue to provide charge capabilities to
your connected devices.
Security and Surface-Mounting
Follow the below procedures for attaching a security cable, or for securing the
ST10CSU2A to a surface.
Note:
Do not attempt to secure or mount the ST10CSU2A while your tablet devices
are connected or stored inside. Ensure the Power Switch is set to the “Off” position and
remove the Power Cord from the ST10CSU2A.
Security Bracket
The ST10CSU2A features a slide-out Security Bracket on the rear upper-center position
of the unit. This bracket can be used with cable locks to secure the ST10CSU2A as
desired.
Surface-Mounting Method 1:
The ST10CSU2A features a slide-out Surface Mounting bracket on the rear lower-center
position of the unit. This bracket can be used with the provided screws to secure the
ST10CSU2A to a desk surface. Pull the bracket outward, insert the screws, and secure
the unit to a desk surface as desired.
