StarTech.com PCISAT2F3U4, Instruction Manual

Page: 8 / 14

Windows 2000/XP
Windows 2000/XP includes native support for USB 2.0 and FireWire and will install the
drivers automatically. Ensure that you have the most current Microsoft Service Pack
installed. When Windows installs these drivers, you may receive a warning that the files
have not been digitally signed. If this occurs, always choose Yes (Windows 2000) or
Continue Anyway (Windows XP) option to complete the installation process. Windows
will require drivers for the Serial ATA controller contained on the card. Complete the
following steps to install the drivers:
1. Windows will launch the Add New Hardware Wizard. Click Next.
2. Choose the Search for a suitable driver... option and click Next.
3. Check only the Floppy disk drives option. Ensure the installation disk is inserted in
the floppy drive. Click Next.
4. Windows will display a message stating that “Windows has found a driver for this
device”. Click Next. Choose Yes or Continue Anyway if you are warned that the
driver file has not been digitally signed.
5. WIndows will display a message that states “Windows has finished installing software
for this device”. Click Finish.
6. Windows will continue to detect and install any remaining new devices. If the Add
New Hardware Wizard is launched again, repeat steps 1 through 6 from above.
Verifying Your Installation
Windows 98SE/ME
1. Go to Start > Settings > Control Panel.
2. Double click System.
3. Click the Hardware tab.
4. If the card does not appear with a red x or yellow exclamation point (!) next to it,
Windows has not detected a problem with the installation and the card should
function normally.
Windows 2000/XP
1. Go to Start > Settings > Control Panel.
2. Double click System.
3. Click the Hardware tab and choose Device Manager.
4. If the card does not appear with a red x or yellow exclamation point (!) next to it,
Windows has not detected a problem with the installation and the card should
function normally.
Instruction Manual
5