Instruction Manual
3
Installation
Installing Drives in the Enclosure
Remove the screws holding the rear panel
1.
in place, then slide the rear panel out from
the enclosure.
Place the first 3.5” SATA hard drive into
2.
the tray, then slide it forward until the drive
interface is firmly connected to the SATA
connector on the SAT3520U2ER/
SAT3520U2ERGB. Repeat this step with
the second 3.5” SATA hard drive, using the
remaining tray.
If you are connecting the SAT3520U2ER to a host computer using an
eSATA port, please note that in order to utilize some of the RAID function-
ality offered by the enclosure, the eSATA port to which the drive enclosure
is connected
must provide
a SATA port multiplier. If the eSATA port
does not offer a port multiplier, only one of the two installed drives will be
accessible.
Please see the table on the following page for further details.