3
Installation
Hardware Installation
1. Connect the USB device that will be shared to the USB IP device server.
NOTE: USB hubs are not supported by the USB IP device server.
2. Connect an RJ45 terminated Ethernet cable from the network to the USB IP device
server.
3. Connect the power adapter to the USB IP device server. The green LED should light
up solid and the yellow LED should blink if connected to the network.
NOTE: The device server uses DHCP by default to automatically obtain an IP address
from the network’s DHCP server (e.g. router). If a DHCP server is not available, the USB
IP device server will use 192.168.1.50 by default.
Software Installation
1. Insert the included Installation CD into the computer’s CD/DVD drive.
2. AutoPlay should automatically launch and display all of the folders on the CD. If not,
open “My Computer” and double-click on the CD/DVD drive.
3. Enter the folder “USB 2.0 Device”, then “Est_E3868” and double-click the file
“USBServer_Setup.exe”.
4. This should launch the software installation wizard. Continue through the wizard
and once complete, the following icons should appear on the desktop: “Launch USB
Server”.
5. The software must be installed on all computers that intend to make use of the USB IP
device server.
Summary of Contents for 8STUSB1000IP
Page 5: ...2 SideView1 SideView2...
