3
Contents
This package should contain:
• 1 x 7-in-1 card reader/writer with 5.25” drive bracket
• 1 x motherboard connection cable
• 1 x 3 ft. USB 2.0 cable
• 1 x bag of screws
• 1 x rear bracket cover
• 1 x driver disk
Installation
This section will guide you through the installation of your card reader and the related
software. Please read through the instructions carefully and complete each step in the
order listed.
Depending on your OS and the configuration of your system, the instructions below may
not be identical to what you see on your screen.
Installing the Panel
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system and remove the cover from a 5.25” drive bay (see
your computer's user manual for details, if necessary).
3. Gently insert the card reader/writer into the open 5.25” bay (after threading the
attached USB cable into the computer) until it is flush with the front of the case.
Make sure the bracket is lined up with the screwholes in the case, and screw the card
reader/writer into place.
4. Thread the attached USB cable out the back of your computer and plug it into a USB
port. You can use the metal rear bracket cover to hold the cable inplace. Finally
screw the bracket cover into an open I/O bracket on the rear of your computer.
NOTE:
If you want to use the front USB 2.0 ports on the card reader/writer, you will
need to use the motherboard connection cable. If you do not want to use the front ports,
you can skip ahead to Step 7.
5. Connect the single end of the connection cable to the pins on your card
reader/writer. The connectors are constructed so that it is difficult to connect the
cable incorrectly.
Summary of Contents for 525FCREADAL
Page 11: ...Revised February 03 2004...
