StarTech.com 410VDSLEXT2, User Manual

Page: 9 / 32

Instruction Manual
5
DIP Switch Settings - Transmitter
The Transmitter Unit has a 4-position DIP switch for configuration of Side, Channel,
Rate Limit, and SNR.
For initial setup, DIP switch 1 is usually set to the upward (OFF) position, ensuring the
unit is set to CO mode (Receiver Unit set to CPE mode by default).
When using the 410VDSLEXT2, one end (Transmitter or Receiver) must always be set to
“CO” mode, while the opposite end must always be set to “CPE” mode.
Setting each unit to CO or CPE mode is usually based on which direction you want
the most bandwidth delivered. “Download” bandwidth, data sent from CO to CPE, is
generally higher than “Upload” bandwidth from CPE to CO.
• If you need higher bandwidth from the Transmitter Unit to the Receiver Unit, set DIP
switch 1 to the upward (OFF) position.
• If you need higher bandwidth from the Receiver Unit to the Transmitter Unit, set DIP
switch 1 to the downward (ON) position.
See the “Configuration Mode Select” section below to set the Receiver Unit to the
appropriate CO or CPE mode based on the mode that was set on the Transmitter Units
DIP Switch setting.
Pin 1 - CO, CPE Switch
OFF
:
If Pin 1 is in the OFF position, the Transmitter Unit will operate in Central Office
(CO) mode.
ON :
If Pin 1 is in the ON position, the Transmitter Unit will operate in Customer Premise
Equipment (CPE) mode.
Pin 2 - Interleave Noise Protection