Various Adjustments and Inspections
Backrest and Nylon Material Adjustment and Inspection
Backrest Height Adjustment
– Illustration 2-7
1) Pull the armrest upwards to the rear. (p.33)
2) Remove the screws (1). After opening up the side Velcro, pull down the inner nylon material, then the
screws, washers, and nuts (2) will be exposed.
3) Remove the screws, washers and nuts (2).
4) The adjustable pipe can move both upwards and downwards. Adjust it to the most appropriate height.
5) Pass the screw the fixed hole and adjustable hole, using a washer and bolt to connect and tighten
–
paying attention to tighten to the extent where the handle is firmly tightened
– so as not to change the
shape of the pipe.
6) Do the same on the other side.
7) Pull the inner nylon material back to its original position. Put the screw in (1). Pay attention to securely
tighten the screw so that the inner nylon material is firmly affixed and not cause the metal ring (washer)
to change shape.
ATTENTION
Ensure that both sides are adjusted to the same height for risk of damaging the wheelchair.
*Ensure that both sides of adjustable holes of the adjustable pipes are even.
Illustration 2-7
Inner nylon material
Handle
Washer
Nut
(1) Screw
Adjustable pipe
Adjustable Socket
Fixed Socket
Ѧ
Screw
Velcro tape
27