Starline ROLDECK 3, Instruction Manual

Page: 4 / 58

RDBIPBMM.03
3
1. Introduction
This manual describes the Assembling of the Starline Roldeck. Read this manual carefully. The installer
must be informed of the contents of this manual. Follow the contents of the manual precisely. Always do
things in the correct order. This manual should be kept on a safe, dry and against sun-protected place.
In case of damage or loss the user may request a new copy of the manual from Starline.
2. Warnings & safety measures
When installing the Starline Roldeck, please observe carefully the instructions and guidelines contained in
this manual. Always perform each step in sequence. If any of the instructions are not clear, please contact
Starline. Subject to technical change without notice. All measurements are in millimetres unless otherwise
indicated.
The Starline Roldeck should normally be assembled by qualified technical personnel (at least 2 skilled
people). We strongly discourage the use of additional components or the omission of components as this
can have a negative effect on the operation and the safety of the Starline Roldeck.
The manufacturer accepts no liability for damage or injury caused by failure to adhere strictly to the safety
precautions and instructions contained in this manual or by negligence during the installation of the product
and any accessories described in this document.
Please note: At low temperatures one cannot transport, dis/assemble, clean and replace the slats. At
low temperatures the slats are very vulnerable.
Translucent, solar and blue slats should not be exposed to
direct sunlight, unless lying on the water-level.
The translucent, solar and blue slats must always be placed
on or under the water level or rolled on the winding shaft
so that these are protected against sunlight.
The slats should only be transported horizontally, by
min. 2 qualified employees.
Condensation can occur in the slats.
The electrical installation must compliance to the current standards and locally applying
installation instructions. The installation should only be connected by an acknowledged
electro technical installer. Possible failures to equipment must be communicated to your
installer. The equipment should be checked 1x p. year by your installer.
GB