StarLine i96
can
12
Successful authorization will be confirmed by sound signals when
ignition switch-on. In addition, authorization is confirmed at closing of
the driver’s door after remote engine starting.
If the tag was not found due to some reasons during ignition switch-on,
the immobilizer will wait for authorization, while issuing intermittent
sound signals. Waiting for authorization will stop when the tag is found
or ignition is switched off. In case of no authorization the engine will be
blocked at a driving attempt.
Authorization by code entry
At ignition switch-on the immobilizer will wait for entry of the owner
authorization code using the standard car buttons (for instance, the
multimedia control buttons on the steering wheel, window raiser
control buttons). The code is entered with the ignition switched-on.
If the owner authorization code is not entered, then if an attempt at
driving is made, the engine will be blocked.
When the drive is over the immobilizer goes automatically to the
“Security” mode in case of tag loss from the visibility zone or in 15
seconds after ignition switch-off, if authorization by means of standard
buttons is used.
Engine blocking
The engine is blocked using the iCAN technology in the “Security”
mode. Thanks to the iCAN technology the immobilizer itself selects an
event for safe engine blocking and support of remote engine starting
systems (depending on supported functions in the car CAN-bus).
Engine blocking will be active until ignition switch-off. Blocking will be
activated again at the next driving attempt. If blocking is repeated 3
times, the engine will be blocked until tag’s appearance or immobilizer
switchover to the «Emergency security deactivation» mode.
