Part Number: 6280
Page 3
Version 1.0
© 2022 Starkey Products, Inc.
9.
Route the power extension wire up to the fuse box you just uncovered, tucking it under the rear
door sill plate as you go (for crew cab trucks).
Remove passenger side door sill
plate carefully.
2
Remove kick panel. First pull
upward, then backward.
3
Press tab while sliding bar to
the side to unplug connector.
4
10.
Locate the large black 36 position connector shown in picture 4. It has a white bar running across
it. It is the third connector from the bottom.
11.
Press the release tab on the top of the connector while sliding the white bar to the side to unplug it.
It will ‘click’.
12.
Unplug the connector and gently pull it out to gain better access to the wiring. Pull back a few
inches of electrical tape wrapped around the connectors’ bundle of wiring, if necessary. Do not use
any tool to remove the electrical tape that could cut wires or otherwise cause damage.
13.
2020-2022 Model Years
: Using the supplied
Blue
wire tap, slide the
White
wire (Pin #26) onto
the wire tap. This wire is a 16ga wire on 2020-2021 trucks. On some 2022+ models, your wire
may be thinner (18ga or 20ga). In that case, you’ll use the supplied Red wire tap.
See picture 5. The wire should sit in the middle of the two teeth. Squeeze down on the wire tap
making sure it snaps closed. Do not cut Wire!
14.
Plug the
red
wire from the Starkey wiring extension into the back of the wire tap. See picture 6.
15.
Re-connect the large black connector. Be certain to pull the white bar to the side to insure the
connector snaps back into place.
16.
Use a 13mm socket or wrench to attach the
black
ground wire to the bolt circled in picture 7.
Re-attach the nut and tighten – SNUG only, do not overtighten.
17.
Return to the vent at the rear wall of the cab and finish passing any remaining slack through the
vent.
18.
Route the wiring along the frame rail to the rear of the truck. Be sure to secure all wiring with the
supplied zip ties.
19.
Connect the Red/Red and Black/Black wires on the Extension wiring/ T-Adapter.
20.
Re-connect both of the negative battery cables to the truck battery. Remember to re-tighten the
bolts.
Slide the wire specified into place
and close wire tap.
5
Plug red power extension wire
into the wire tap.
6
Attach black ground wire to the
13mm bolt circled above.
7
