Part Number: 3600 / 3650
Page 3
Version 1.0
© 2016 Starkey Products, Inc.
7.
Install the replacement mini-fuse/ fuse tap.
8.
Plug short red wire coming from wiring harness into the fuse tap you just installed. Route the red
wire out of the fuse box as shown in picture 9 below.
9.
Use an 8mm socket or wrench to attach the
black
ground cable ring terminal to the bolt shown in
picture 10. Re-attach the bolt so the ring terminal makes proper contact and the bolt is tight.
Be sure that the bolt is re-attached
tightly enough that it will not loosen.
Make sure tan fuse is seated properly in
fuse slot (position 66).
Plug-in red wire and route wire out.
Arrow at bottom shows orientation.
10.
Route the wiring for the driver side fog light/ switch over the radiator along the frame of the car.
11.
Drop the wiring for each light down to the fog light locations. Route wiring for the passenger
compartment (green wire) along the driver’s side fender towards passenger compartment.
12.
Plug the fog light connectors into the fog lights.
13.
Open the drivers’ side door and locate rubber boot to the left of the pedals. It is hidden behind an
insulation pad. Carefully push to remove from the firewall. See picture 11. This is where we want
to route the green wire into the passenger compartment.
14.
The easiest way to do so is to route the wiring down past the brake booster toward the ground.
Follow the existing bundle of wiring. Tip: Shine a flash light through the hole in the passenger
compartment – this will assist you in feeding the wires down to the proper opening/ area.
15.
While inside the passenger compartment, pull the switch wiring through the firewall.
16.
Re-install rubber boot in the firewall by gently pulling it back into the hole. This will be a little bit
more difficult with the additional wiring running through. Make sure it seals well. If you find this
difficult, you can optionally cut a hole in the rubber boot and feed the wire through that way. Just
be sure you don’t damage the wiring bundle that runs through the center of the rubber boot.
Installing switch in passenger compartment:
1.
Use a flat head screw driver wrapped in a rag to carefully remove the panel below the switch
panel. This will help allow switch removal. See picture 12. 3 clips hold the panel in place.
Attach ring terminal to bolt circled
above. Firmly re-tighten the bolt.
Push boot carefully but firmly out of
the firewall. Then pass wire through.
Pry downward with screwdriver
wrapped in a rag.
