Sivu 12 / 23
7.5.
Detaching the bucket sweeper from the base machine
1.
Lower the bucket sweeper down on an even surface. Lift the brush roller so that the brush rings are not pressed
against the ground.
2.
Turn off the base machine, apply the parking brake and depressurize the system.
3.
Detach the hydraulic hoses and protect hose ends with plugs.
4.
Unlock the coupling mechanism and detach the device.
5.
If the equipment is not likely to be used for a longer period of time, clean it thoroughly after operating and
lubricate as instructed. Remove water from containers and hoses. Remove irrigation nozzles and store them
inside. If possible, store the device indoors.
7.6.
Accessories
The following accessories are available for the bucket sweeper:
-
Low-pressure watering system, with container size 155L
-
High-pressure dust suppression system with high pressure pump, with container size 155L in model KAH 2000
S, and with size 255L in models KAH 2500S and KAH 3000 S.
-
Support rollers
-
Side brush with hydraulic lifting (right and left side)
-
Mechanical side mover
-
Pin Float -fitting
-
High pressure washer
Note about the watering system:
1.
Use fresh water only in the watering system.
2.
Water is sprinkled to the area to be cleared to suppress dusting. Place and point the nozzles for the best
possible result. The nozzles can be placed and pointed, for example, towards road edges, where dusting is
likely to be heavier.
3.
The total of 7 hoses and nozzles are delivered; hoses can be taken into and out of use as needed.
4.
The amount of water consumption depends on the number of nozzles. One nozzle consumes appr. 1L/min.
5.
If the watering system is not likely to be used for a longer period of time, it is advisable to run a mixture of
cooling liquid and water through the system in order to prevent corrosion. After this, make sure the container
and hoses are empty. Remove the nozzles and keep indoors.
