Stark 66012, Owner'S Manual And Safety Instructions

Page: 7 / 14

6
The tail stock assembly and tool rest are held to the bed with
the lock handle right underneath the bed rails. To move them
to a new position:
1.
Disconnect the lathe from power source.
2.
Loosen the lock handle with the knob.
3. Slide the tail stock assembly or tool rest along the bed
and re-tighten the lock handle.
MOVING TAIL STOCK ASSEMBLY AND TOOL REST
The lathe must be mounted to a firm supporting surface such
as a stand or workbench when operating. To mount lathe:
1.
Disconnect the lathe from power source.
2.
Locate and mark where the lathe is to be mounted.
3.
Drill four 5/16” diameter holes through the workbench.
MOUNTING THE LATHE
4.
Place the lathe on the workbench, aligning holes in the
bed with holes drilled into the workbench.
5.
Insert four bolts (sold separately) and tighten.
To remove the tail stock spindle from the tail stock assembly:
1.
Disconnect the lathe from power source.
2.
Remove the hand wheel by loosening the set screw with
1/8” hex wrench away from the spindle. See Fig. 1
3. Unscrew tail stock spindle from the tail stock assembly.
See Fig. 2
REMOVING TAIL STOCK SPINDLE
Fig. 1
Fig. 2
The Drive Stock center must be removed to attach to the stock
when the spindle is turning. It also needs to be removed when
attaching the faceplate for turning the faceplate. To remove
the drive center from driving spindle.
1. Disconnect the lathe from power source.
2. Using a wrench, hold the flat neck of the driving spindle,
then unscrew the drive center counter-clockwise.
REMOVING DRIVE CENTER
OPERATION AND ADJUSTMENTS