Stark 1200CFM, Owner'S Manual And Safety Instructions, Page: 7 / 19

ASSEMBLY
This walk-behind blower was partially assembled at the factory. To assemble your machine follow the below
instructions.
1. Insert the end of the front swivel caster tube into the
opening of the frame tube, align the holes.
2. Attach the tubes to the engine deck with M8x40 bolt, arc
washer, spring washer and lock nut in four places. Tighten
securely using two 13mm wrenches.
1. Install one spacer onto the wheel axle.
2. Slide the wheel onto the axle.
3. Secure the wheel in place with a flat washer and a cotter
pin on the outside. Bend and spread the cotter pin prongs in
opposite directions.
4. Repeat these steps to install the 2nd wheel.
FRAME
WHEELS
1. Install one bushing onto the top shaft of the swivel caster
bracket with the smaller end of the bushing facing upwards.
2. Ins
tall th e caster tube onto the shaft with the busing
inserted into the tube.
3. In
s tall the 2nd bushing onto the shaft and insert it into the
caster tube.
4. Secure the caster tube in place with a flat washer, spring
washer and acorn nut. Tighten securely using a 16mm
wrench.
SWIVEL CASTER
5 6