BeiJing Starfire Control Technology Co.,Ltd
WeChat:18901200180
QQ: 1908817881
27
[uniform acceleration time] : motor speed regulation auxiliary parameters, the greater the inertia of the machine tool,
the smaller the setting value, the recommended value is 0.2.
[blank speed] : the blank speed of cutting gun, namely the maximum blank speed that the machine tool can bear. The
recommended value is 4000.
[reset speed] : the speed of the machine tool back to the mechanical zero. If the speed is set too high, it will
overshoot at zero. The recommended value is 2000.
[fallback/forward speed] : the walking speed when pressing the fallback key or the forward key, generally used for
accurate positioning of the cutting gun, the value is 1000.
[corner velocity conversion Angle] : -- when the running direction between program segments changes beyond this
Angle, the system corners will slow down to the starting speed.
This value is usually chosen to be smaller when the system is heavier. The timing can be determined according to the
processing speed and vibration of the machine tool. Large vibration, select small value.
[corner arc transition radius] : when running small line segment program at high speed, if the machine tool has
vibration, the radius can be appropriately increased, generally in 3-5mm, the recommended value is 5.
[arc speed limit] : the speed when cutting the arc, generally used for cutting small round holes, the recommended
value is 500.
[arc speed limit radius] : when cutting an arc, the speed limit starts when the radius of the arc is less than this value.
6.2 system parameters
[pulse equivalent] : it is used to adjust the machining accuracy of the machine tool. It shall be calculated or accurately
measured according to the design of the machine tool. The unit is mm/pulse. Press G, G and 2 on the parameter
home page, and press the prompt to set the pulse equivalent automatically.
[machine tool origin offset] : after the machine tool returns to the mechanical zero, offset the distance again, and
then set this position as the mechanical coordinate 0.
[reference point] : in the program, the origin of coordinates set after G92 execution is generally 0.
Line offset: the offset between the drill hole, the powder gun, and the cutting gun.
[reverse clearance] : the reverse clearance generated in the manufacturing process of the machine tool can be set to
make up for the error, but this compensation is only rough compensation. It is suggested to adjust the mechanical
part to eliminate the error.
