BeiJing Starfire Control Technology Co.,Ltd
WeChat:18901200180
QQ: 1908817881
23
2) the method of edge perforation is: move the cutter gun to the nearest edge of the steel plate before perforation.
3) start preheating. When the preheating is finished, press the [start] button to cut the cutter along the straight line
and at the selected cutting speed to the perforation point, and then continue cutting.
2)
when using edge perforation, first change the selection of edge perforation in the control menu in the parameter
to 1 (indicating that the selection is valid). In this way, when each hole is punched, the system first prompts the
following figure:
3)
Current position punch
Perforation at the original position of the system, usually on the inner bore;
Edge piercing
1) the operator can press
【
↑
】【
↓
】【
←
】【
→
】
key to adjust the position of the cutting gun to the outer edge of
the steel plate and start preheating;
2) when the preheating is finished, press the [start] button to cut the gun along the straight distance and selected
cutting speed to the perforation point, and then continue cutting.
Don't punch
