Starblitz SHARK200, User Manual

Page: 12 / 44

10
EN
FR
ES
The following picture shows how to set the same groups between flash light and
remote controller.
Group number on
SHARK Studio Flash
Corresponding group
on remote controller EX-801C
G.A
Group 1
G.B
Group 2
G.C
Group 3
G.d
Group 4
Press the slave button 8 seconds, or wait 20 seconds to quit to output power page.
Audible Beep Settings
Push the Beeper Button
5
(Fig.1) to ‘ON’ to give a short beep when the unit is ready
to fire, to provide an audible “Ready confirmation”.

Turning the switch
5
(Fig.1) OFF will allow the modelling lamp to turn off auto-
matically while the flash is fired.
Flash Output
- The flash power output is variable over a 5 f-stops range (6 f-stop points) from full
to 1/32 in 1/10 f-stop increments using two power regulator adjustment buttons
1
(Fig.1) on the rear panel.