– 8 –
<Settings for Communication Speed>
To change the serial communication settings, change the following DIP switch settings.
(Ex-factory Default Settings: DSW 1 to 6 are ON, 7 and 8 are OFF.)
Switches
ON
OFF
DSW 1-1
Baud Rate Setting (See table below)
DSW 1-2
DSW 1-3
8 bit
7 bit
DSW 1-4
Parity Disabled
Parity Enabled
DSW 1-5
Odd Parity
Even Parity
DSW 1-6
Fixed at On
DSW 1-7
Fixed at Off
DSW 1-8
Fixed at Off
Baud Rates BPS
4800 BPS
9600 BPS
19200 BPS
38400 BPS
DSW 1-1
OFF
ON
ON
OFF
DSW 1-2
ON
ON
OFF
OFF
* Mistaken DIP switch settings will cause the reader/writer to mis-operate or reader/
writer failure. Be careful when making setting changes.
To change the DIP switch settings, do the following.
1. Check that the power is turned off for both the reader/writer and the host computer.
2. Remove the two screws.
3. Pull out the serial interface card to remove it.
4. Change the DIP switch settings on the serial interface card.
5. Push in the serial interface card to mount it.
6. Tighten the two screws.
7. Turn on the power for both the reader/writer and the host computer.
Note: The new settings will take effect when the reader/writer power is turned back on.
DIP Switches
