- 10 -
Memory Switch Setting Table
Printer Mode
Setting
Display
1
Communication Port
*1
）
Bluetooth(iOS) *
Bluetooth(iAP)
Bluetooth
Bluetooth Mode
RS-232C
UART Mode
2
Baud Rate
9600 bps
9600 BPS
38400 bps
38400 BPS
115200 bps *
115200 BPS
3
Parity Bit
No Parity *
NO PARITY
Odd Parity
ODD PARITY
Even Parity
EVEN PARITY
4
Stop Bit
1 Stop bit *
1 STOP BIT
2 Stop bit
2 STOP BIT
5
Print Density
Density Low
DENSITY LOW
Density Medium *
DENSITY MEDIUM
Density High
DENSITY HIGH
6
Print Speed
Low (50mm/s) *
LOW SPEED
High (80mm/s)
HIGH SPEED
7
Black Mark Sensor *2
）
No use *
MARK NO USE
Use
MARK USE
8
Black Mark Sensor Sensitivity
Low *
SENSOR LOW
Medium 1
SENSOR MEDIUM1
Medium 2
SENSOR MEDIUM2
High
SENSOR HIGH
9
Power Down
No use *
PWDN NO USE
1 Minute Sleep
PWDN 1 min.
2 Minute Sleep
PWDN 2 min.
3 Minute Sleep
PWDN 3 min.
4 Minute Sleep
PWDN 4 min.
5 Minute Sleep
PWDN 5 min.
*
1
)
Communication mode
It is possible to change the communication mode setting between Bluetooth and serial. Please
see below for details to select the proper communication mode for your application.
Bluetooth (iOS):
The display shows [Bluetooth(iAP)]. At the Bluetooth (iOS) mode, the printer can communi-
cate with an iOS device over Bluetooth.
Bluetooth:
The display shows [Bluetooth Mode]. At the Bluetooth mode, the printer can communicate
with an Android device or a device other than iOS devices over Bluetooth.
RS-232C:
The display shows [UART Mode]. At the RS-232C mode, the printer can communicate with
a device using the serial communication cable supplied with the printer. When you con-
nect the serial cable, the printer is automatically switched to serial communication from
Bluetooth communication.
*
2
)
When the black mark sensor is set to Use, the printer cannot detect the paper–end status.
