page
48
page
49
Operating Procedures
All vehicles have an interlock system that disables the controller and prevents
operation or tow of the vehicle while the charger is connected. Remove the
charger plug from the receptacle and correctly store the cable before you move
the vehicle.
To operate the vehicle:
•
Turn the key switch on, select desired direction.
•
Slowly press the accelerator pedal to start the motor.
•
When the accelerator pedal is released, the motor decreases the speed of
the vehicle. To stop the vehicle quickly, press the brake pedal.
When the direction selector is in the reverse position, a warning signal
will sound to indicate that the vehicle is ready to run in reverse.
Read all of SAFETY and this section before attempting any procedure.
Pay particular attention to Notices, Cautions, Warnings and Dangers
HIGH PEDAL DISABLE FEATURE
STARTING AND DRIVING
COASTING
Uncontrolled coasting is not a substitute for the brake which must be used to
quickly decrease the speed of the vehicle.
High pedal disable prevents acceleration if the key is turned on while the
accelerator or brake are pressed. To reset the controller after a High Pedal
Disable, place both feet on the floor, turn the key to the
OFF
position.
With both feet on the floor turn the key on, select desired direction, and
press the accelerator. To start the vehicle on a hill press the accelerator pedal.
STARTING VEHICLE ON A HILL
To start the vehicle on a hill press the accelerator pedal and the parking brake
will be released.
Summary of Contents for CAPELLA CP-2
