SPINNER BLADE BELT BIKE MANUFACTURED by STAR TRAC - OWNER’S MANUAL |
13
A
ssembly &
S
etup
Use the following procedures to unpack and assemble your
Spinner
®
Blade Belt Bike manufactured by Star Trac
.
UNPACKING
AND
PARTS LIST
Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the carton and fold back all four flaps.
Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping carton and foam
inserts, and verify that the following parts are included in your shipment:
Spinner Blade Belt Bike Parts List
Description
Qty.
Description
Qty.
Main Frame Assembly
1
M8x1.25x30mm Hex Head Bolt
4
Handlebar Post
1
8mm Split Lock Washer
4
Handlebar w/ Grip & Water Bottle Holders
1
8mm Plain Washer
4
Seat Post
1
Threaded Two Hole Footplate Bar
2
Seat and Slider Assembly w/ Saddle
1
Seat Adjustment Pop-Pin
1
Front Leg Assembly w/ Transport Wheels
1
M8x1.25x14mm Specialty Hex Bolt
2
Rear Leg Assembly
2
Pedals (set of two)
1
Tool Kit
1
Take time now to enter your Spinner
Blade serial number in the space below (serial number is located on the bottom cross member).
If parts are missing, or if you have any operational questions, please call Star Trac’s Service department at (800) 503-1221.
Have your serial number ready.
Serial No._____________________________________________
NOTE:
If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been
overlooked.
If parts are missing, or if you have any product questions, please call Star Trac’s Service Department at (800) 503-1221, please have
your Spinner’s serial number ready.
CAUTION:
Damage to the bike during assembly is not covered as part of the limited Star Trac warranty. Take care not to drop or
lean the bike on the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip
over during assembly.
