Star Trac IP-S3341, Installation Instructions Manual, Page: 5 / 12

Page 5
INSTALLING COUNTER BALANCE:
CAUTION: Counter balances are 28kg (62lbs) each and
may require two people to install.
1. Face the COUNTER BALANCE with the STAR
TRAC logo facing away from the equipment frame
as shown. Also ensure that the large end of the
COUNTER BALANCE is above the stop bracket.
Press the COUNTER BALANCE onto the shaft
until both bearings are entirely pressed onto the
shaft.
2. After the COUNTER BALANCE has been pressed
onto the shaft install and tighten the
(M8,25MM,Hex Bolt) & (M8,Washer) using a
13mm socket. The counter balance should now
pivot freely.
3. Repeat steps 1 and 2 with the second COUNTER
BALANCE on the opposite side of the equipment.
INSTALLING THE ARM:
1. Find the ARM that is marked A and align the ARM
so that it is positioned in the opposite direction as
the COUNTER BALANCE as shown.
Using four
(M8,20MM,Button Head Bolts) with four
(M8,washers) Install and tighten the ARM using a
5mm hex key socket. Verify that the arm rotates
smoothly.
2. Using two (M5,12MM,Button Head Bolts) install
the TRIM RINGS as shown, using a 3mm hex key
socket.
Torque bolts to 1.1 N-m MAX .
INSTALLING STOP BRACKET:
1. Orient the STOP BRACKET with the black rubber
stops facing up and align the four holes in the
STOP BRACKET with the four M8 threaded inserts.
Install four (M8, 25MM,Button Head Bolt) and four
(M8,Flat Washers) and tighten using a 5mm hex key
socket.
A