Page 5
8.
Reinstall Back PVS Shroud and align the PVS
grommet.
9.
To install the controller, remove the front of the
console, then use a #2 phillips screwdriver to
remove the screw securing the blank cover to the
console.
10.
Replace the blank cover removed in Step 6 with
the PVS controller then secure using the same
screw removed in Step 6.
11.
Use the diagram (right) and the table below
to connect the PVS cabling to the appropriate
location:
(1)
PVS Power to supplementary power cable from
unit.
(2)
PVS Controller (installed in Step 7).
(3)
3.5mm Audio Cable to hotbar OR USB panel.
(4)
USB Port (used for software updates).
(5)
HDMI In
(6)
Coax In
NOTE:
The RJ45 jack on the right of the PVS is not
used.
