– 15 –
4-2. Attaching the Holder Plate
•
The holder plate is attached to the printer using the included screws and is hooked onto
screws that are installed into the wall.
•
The screws on the wall are not included.
Use commercially available screws (4 mm diameter) that are suitable for the wall material
(wood, steel beam, concrete, etc.).
•
The printer’s weight is approximately 2.4 kg when the largest diameter roll paper is loaded.
Use screws on the wall that have both shear strength and pulling-out strength to withstand
a force of at least 12 kgf (118 N).
Precautions regarding installation
CAUTION
This caution indicates information that, if ignored, could lead to personal injury or property
damage.
• Be sure to have qualified personnel install the specified screws and printer to the wall.
Star is not responsible for any accidents or injuries that occur as a result of improper installa-
tion, misuse, or modifications.
Especially when installing the printer at a high location, make sure that the printer is securely
installed to the wall.
If the printer is not installed securely and falls, personal injury or damage to the printer may
result.
• Make sure that the mounting surface and installation screws are strong enough to install the
printer.
Securely install the printer so that the weight of the printer and any connected cables will not
cause the printer to fall.
Otherwise, personal injury or damage to the printer may result.
• Do not install the printer in an unstable location or a location that is exposed to vibration and
shocks.
If the printer falls, personal injury or damage to the printer may result.
