Star Micronics SF-10HA, User Manual

Page: 6 / 42

2 SF-10HA Automatic Sheet Feeder
Preparing the printer
❏
Enter the printer’s EDS Mode and make the setting that tells the printer that
the ASF is installed (for example, Bank A, Switch 4 is OFF on LC-1021
model). Refer to the User’s Manual that comes with the printer for details
on using the EDS Mode.
❏
Unplug the printer from its AC power source.
❏
Open the mute cover of the printer.
❏
Push the release lever back to the cut-sheet position.
❏
Open the rear cover by pushing it back so the cover swings back and down.
❏
Break away the two small pieces from the rear cover as shown in the
illustration above.
Repeatedly press down where indicated by the arrows a number of times
until the tabs weaken and the pieces break free.
❏
Close the rear cover.
Installing the automatic sheet feeder
❏
If you have not already done so:
✓
Make sure that the printer is unplugged from its AC power source.
✓
Open the mute cover and rear cover of the printer.
✓
Push the release lever back to the cut-sheet position.
✓
Remove the small pieces from the rear cover.
✓
Close the rear cover.
See the procedure under “Preparing the printer” in the previous section for
details.
Mute cover
Rear cover
Release lever