11
4. Functions
4.1 Function setting
DIP SW for Serial
Function On
Off
Factory setting
S-1 Baud
rate
38400
19200
Off
S-2 Character
setting
Non-Japan
Japan
Off
S-3 Emulation
select
Windows ESC/POS
Off
S-4
Japanese character code
Shift JIS
JIS
Off
S-5
Fixed partition select
2 partitions
1 partition
Off
S-6
Flash ROM rewrite
Rewrite
No
Off
S-7 Near
end
Enable
Disable
On
S-8 Print
density
High
Standard
Off
S-9
Serial control (DTR)
XON/XOFF
DTR/DSR
Off
S-10
Off
* No parity check (fixed)
* Data bit: 8 bits (fixed)
DIP SW for USB
Function On
Off
Factory setting
S-1
Off
S-2 Character
setting
Non-Japan
Japan
Off
S-3 Emulation
select
Windows ESC/POS
Off
S-4
Japanese character code
Shift JIS
JIS
Off
S-5
Fixed partition select
2 partitions
1 partition
Off
S-6
Flash ROM rewrite
Rewrite
No
Off
S-7 Near
end
Enable
Disable
On
S-8 Print
density
High
Standard
Off
S-9
Off
S-10
Off
1. Rewrite the Flash ROM as
1) Set the DIP SW below
2) Change CN8 #1 pin LF to L, or set PWR on, holding Feed SW on operation panel. Set
PWR off to end.
2. For rewriting the flash ROM boot program; set both S-6 and S-2 on.
3. For rewriting flash ROM firmware; set S-6 on and S-2 off.
Important
: Set S-6 off except for rewriting. If set it on, the program may be damaged.
4.1.3 Self-print
1) Confirmation by self print function
a. function of control circuitry
b. function of printer mechanism
c. print quality
d. version of control firmware
e. DIP switch setting status
f. operation of no paper sensor
g. check of head width and head rank (auto sensor)
2) Start and end of self print
Set the power switch on while FEED SW is being pressed, or release FEED button after
input of Reset signal to start self-print. It automatically stops with set patterns printed. While
self-print is under operation, printer status is in OFF LINE.
