Star Micronics LS-5 SERIES, Technical Manual

Page: 137 / 204

CHAPTER 6
PARTS LIST
HOW TO USE PARTS LIST
(1) DRWG. NO.
This column shows the drawing number of the illustration.
The assemblies or units of boards described as “PLX” (where X represents a number) in this column in “Section
6 Electrical” show that they have been disassembled into lower-level parts in “Section X.”
The screws and retaining rings used all section are described in “Section 17. List of Standard Fasteners”.
(2) REVISED EDITION MARK
This column shows a revision number.
Parts that have been added in the revised edition are indicated with “#”.
Parts that have been abolished in the revised edition are indicated with “*”.
#1: First edition
→
Second edition
*1: First edition
→
Second edition
(3) PARTS NO.
Parts numbers must be notified when ordering replacement parts.
Parts described as “NPN” have no parts number and are not in stock, i.e., unavailable. When these parts are
necessary, place orders for parts (assemblies or units) of higher level. Their drawing numbers are described in
the “ASSY” column.
(4) PARTS NAME
Parts names must be notified when ordering replacement parts.
(5) Q’TY
This column shows the number of the part used as indicated in the figure.
The following abbreviations show the printer model.
EX ........... LS-5 EX
TT ............ LS-5 TT
LC ........... LS-5
(6) REMARKS
When there are differences in the specifications of the fuse, destinations, etc., the differences are described in
words or indicated by two letters.
US ... U.S.A. EC ... EC UK ... United Kingdom HK ... Hong Kong
AS ... Australia JP ... Japan
The seal number of EP-ROM is described in this column. The “*” mark of seal number is a variable representing
on the software version.
“WITH 2-6” shows that drawing numbers 2, 3, 4, 5 and 6 are included.
“J1
↔
J2, J3” attached to parts such as harnesses and wires, shows that one end of a harness or wire is Jack J1
of a connector and another is its J2 and J3.
For the locations of connectors (P/J), refer to “Connector P/J Arrangement, Section 4, Chapter 4.”
(7) RANK
Parts marked “S” are service parts. Service parts are recommended to be in stock for maintenance.
(8) ASSY
This column shows drawing numbers of higher-level parts (assemblies or units) of those described as “NPN”
in the “DRWG. NO.” column.
6