PART FIGURE
Height
adjustment ring
Base
“7” Finger screw
Fasten
Extension
pole
Internal Pole
Spinner
Loosen
Tighten
Tilt adjustment knob
Fan body
Back Guard
Circlip
Speed
Regulator
Motor
Oscillating Knob
Motor shaft
Blade
Plastic sleeve
Plastic Nut
Front Guard
1. Unscrew the “7” finger screw
from the Extension Pole. (Fig.1)
2. Insert the extension pole in the chassis and tighten the “7” Finger screw. (Fig.2)
3. From the extension pole loosen the height adjustment ring and adjust the internal
pipe to the desired height. (Note: If you can’t find the internal pole, it slides inside
the extension pole. You can pull it out from the extension pole.) (Fig.3)
4. To attach the head unit to the extension pole, loosen the thumb screw on the
bottom of the head unit. Place the head unit on the extension pole and tighten the
thumb screw in alignment with the groove on the internal pole. (Fig.4)
CAUTION:
Height adjustment ring must be fully fastened before the assembly of
the motor section to the extension pole.
ASSEMBLY OF CHASIS & COLUMN UNIT
Fig.1
Fig.2
Annular groove
Mounting hole
Thumb screw
Fig.3
Loose
Fig.4
7
