9
Monthly Lubrication/Inspection
Apply two (2) drops of non-toxic mineral or vegetable oil to counter balance shoulder rivets
and plastic spacers.
Check and clean brass rollers to make sure they are rolling and not sliding on the cam
surfaces of the counterbalance.
Check the bolts, screws and nuts, tighten if necessary.
Cleaning
Begin cleaning procedure by using the operating procedures within your organization, or follow
the steps below:
1. If particles adhere to the cooking surface during the day, scrape them off with a spatula.
NOTE:
It is best not to let food cook onto the grill, as food build-up on the grill will increase
sticking and smoking. In addition, carbon may build up on the grill surface and reduce the
cooking ef
fi
ciency.
Carbon Buildup:
A black matter that forms on or near the cooking surface. Generally this is a
combination of: releasing agents, oils, food particles etc. ,that have cooked to the surface.
After a period of time without cleaning, this will reduce performance and material may start
fl
aking off. When that happens, follow the "Carbon Cleaning" procedures.
2. At the end of the day, wipe down all surfaces with a warm, damp cloth and mild detergent,
then dry.
Carbon Cleaning
When carbon build up occurs, use a carbon removal agent (safe for aluminum surfaces)
according to the instructions provided with the cleaner. When this process is complete, you
must re-season the grill according to your company/corporate guidelines, or the seasoning
instructions in this manual.
CAUTION
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON
THE TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
DO NOT USE SHARP OBJECTS TO REMOVE CARBON BUILD-UP.
DO NOT USE ICE ON THE COOKING SURFACE!
BEFORE CLEANING MAKE SURE POWER IS TURNED OFF, UNIT IS
UNPLUGGED AND IS NOT TOO HOT.
While holding top lid with one hand, apply only cleaners which are safe for aluminum
and iron surfaces. Wipe with clean sponge or towel until unit is clean.
DO NOT SPLASH FRONT CONTROL PANEL!
DO NOT SPLASH FLEX CONDUIT CONNECTING TOP AND BOTTOM OF THE
UNIT.
Remove and empty to clean grease catcher drawer as required using mild detergent and
water.