-5-
Advanced Programming
Advanced Programming is optional. Most users will NOT need to program any of
these features. If the default settings are acceptable, skip to the Operation section.
Advanced Programmable features include the following:
Head Enable (which heads activate with each function)
Phase Selection (which heads alternate and which flash simultaneously)
Changing the Wire Functions
TD/Warning Pattern Cycling
Resetting to Factory defaults
Title 13 Programming
If you wish to change the programming for any of these features please review the Phaser
Advanced Programming Manual which can be found at:
http://star1889.com/APM
or by contacting Customer Service at 585-226-9787 or [email protected].
Operating Instructions
Functions Switched Through Wires
Main control of this light is done though the wires in the harness. They should be connected
to +12VDC through several switches
(user supplied)
as described in the
Wiring
section.
Priority 1 Flashing
This is usually intended as a slower, less urgent mode typically used when parked.
Priority 2 Flashing
This mode is intended for moderate-urgency situations, such as a low speed chase,
requiring some warning power. It is usually a faster pattern than Level 1.
The Level 2 pattern will override Priority 1 lights.
Priority 3 Flashing
This mode is intended for high-urgency situations, such as a high speed chase, requiring
significant warning power. It is usually a faster pattern than Level 1 or 2 and/or may utilize
more lights.
The Level 3 pattern will override both Priority 1 and Priority 2 lights.
All Additional Functions
Any additional functions that were designed into the lightbar will have corresponding
control wires that are labeled on the
Cable Assembly Checklist
enclosed with your bar.
Ap12VDC to any of these wires will activate the corresponding function.
