-3-
Wiring
For proper installation and full operability, this light requires a 10.5A ignition switched
power source, connections to the negative terminal of the battery, and four external
switches rated for a minimum 1A
(user supplied)
.
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load.
Testing the light before this fuse is properly
installed will void the warranty on the light.
Please Note:
When the red wire is connected to +12VDC the light will draw a small current (5
mA). Occasionally vehicles may sit for extended periods of time (i.e. more than a
few days), thus we recommend that the red wire be routed through an ignition
switched power source.
Operating Instructions
Main control of this light is done though four of the wires in the harness. They should be
connected to +12VDC through 4 switches
(user supplied)
as described in the
Wiring
section
above.
Located on the bottom of some versions of
The Star Phantom
®
, is an Indicator LED. When
your light is activated in any mode, this LED will flash to alert you to the lightbar activity in the
daylight.
Active Mode
Indicator LED Display
Warning LED Flashing Mode
Fast Flash
DLP LED Flashing Mode
Slow Flash
(overrides Fast Flash)
Warning LED Steady Burn or
DLP Takedown (Steady Burn)
Steady
(overrides Fast or Slow Flash)
Warning LED Burst Mode
Flicker
(overrides Steady, Fast or Slow Flash)
Indicator LED
(some versions)
ORANGE w/RED - Flashing Warning Lights
GREEN w/RED - Steady Burn Warning Lights
WHITE w/BROWN - Pursuit Lights
(Flashing DLP)
GREEN w/YELLOW - Takedown Lights
(Steady Burn DLP)
RED - Ignition Sw12VDC
BARE
BLACK
