PLIT618 REV. A 1/21/22
Quick Stick Arrow Board
NOTICE
Due to continuous product improvements, we must reserve the right to change any specifications and information,
contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of
any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose. Star Headlight & Lantern Co., Inc. shall not be liable for errors contained herein
or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual.
Important
: This product is used to
direct
traffic. Improper use may result in vehicular
collision, personal injury and/or death. Star Headlight & Lantern Co., Inc., and its
subsidiaries shall not be held responsible for damages directly or indirectly caused by
improper use of this product. Always carefully consider the effect on traffic that the
selected light pattern will have before engaging the lights.
Please Note:
These instructions are provided as a general guideline only. Specific
mounting and/or wiring, may be necessary and are the sole responsibility of the
installer. Star Headlight & Lantern Co., Inc. assumes no responsibility for the
integrity of the installation for this or any of its products.
DLQS-ARO
DLQS-ARO2
-2-
1. There is a slot along the length of the back of the
arrowstick that should be used to facilitate mounting.
Insert the heads of the two enclosed #10 carriage bolts
into the hole in the slot.
2. Slide them along the channel to the desired location and
mark the locations for your mounting holes on the
mounting surface.
3. Drill your holes and mount the light using the enclosed
washers and nuts.
We also include two L-Brackets to facilitate mounting.
These are optional and do not need to be used.
Prior to mounting the light, determine
the path your cable will take. The cable
should exit the left side when you are
facing the lights on the arrowstick
mounted on the rear of the vehicle.
Mounting Instructions
Operation
Using your user supplied switches, 12VDC to the wires indicated in the wiring
diagram on the next page to activate the desired function.
Please note the following:
•
The Red wire MUST have +12VDC applied to it for any of the functions to work.
•
Activating the
Left Arrow
and
Right Arrow
together will produce a
Center-Out
display in the pattern programmed for Left.
•
Activating the
Left Arrow
or
Right Arrow
will override either
Warn
pattern.
•
Warn 1
(Full Arrowstick)
will override
Warn 2
(Arrow Tips Flash).
•
Dim
will dim all of the heads by 85%, which may be desirable in night time
conditions.
