Page
SPS5.1 Manual
6
2.5
Firing Displays
This is shown when a delayed start is in progress. The display
shows the hours:minutes remaining until firing commences.
This shows that the initial ramp, ramp 1 is being fired. For addi-
tional information press the
Æ
key. This additional information
is also displayed once per minute.
This shows that the final ramp, ramp 2 is being fired. Press the
Æ
key for additional information.
This shows that the controller is soaking. Press the
Æ
key for
additional information including the time left in soak.
This shows that the soak period is complete and that the load is
cooling naturally.
HOT!
is displayed flashing.
This shows that the load has cooled to less than 100°C.
This shows that the load has cooled to less than 40°C & firing is
complete.
DELAYED START...
TIME LEFT 04:32
SLOW HEATING...
à
KILN TEMP 23°C
FAST HEATING...
à
KILN TEMP 817°C
SOAKING...
à
KILN TEMP 1200°C
COOLING... HOT!
KILN TEMP 1172°C
COOL
KILN TEMP 96°C
READY
SPS5.1 Manual
Page 7
2.6
Power Fail Recovery
In the event of power failure followed by power restoration, the instrument attempts to take
intelligent recovery actions to avoid a firing being aborted. The instrument has no direct
knowledge of how long the power has been off so the recovery action taken depends on where the
instrument had reached in the firing sequence prior to power failure as detailed below:-
Before Power Failure
After Power Failure
In
READY
mode
Timing delayed start
On Ramp 1 approaching t1
On Ramp 2 approaching t2
In Soak Period timing Soak
Time
Cooling after SOAK period
In
READY
mode
Immediate start as if the end of Delay Time reached
Immediate restart. Temperature will increase at ramp rate
1 of the current program starting at the present temperature
Immediate restart. If present temperature greater than t1
temperature will increase at ramp rate 2 of the current
programme starting at the present temperature. If present
temperature is less than t1 temperature will increase at
ramp rate 1 of the current program starting at the present
temperature
As above. The full soak period of the current program will
be re-applied
Cooling continued.
Installation Category: II
Pollution Class: 2
3.0
Installation Instructions
3.1
Safety
ISOLATE
BEFORE
REMOVING
COVER
230V ~ 50HZ 1.0A
Fuse: 1.0A Anti-surge
Wickmann type TR5 T1A 250V
WARNING
ISOLATE FROM ELECTRICAL SUPPLY BEFORE OPENING THIS
INSTRUMENT FOR INSTALLATION, CONFIGURATION OR REPAIR
PURPOSES
