15. Headphone output: Connection for 1/4 inch headphone. Recommended headphone
impedance is 32-200 ohms for maximum volume.
16. Master output: TRS balanced (1/4”).
17. Power switch: Selects power "ON" or "OFF".
18. Power supply connector: Input connection for the accompanying power supply.
19. Ground connector: Connects to the turntable ground connector to eliminate electrical
hum. Ground connectors usually supplied with turntables.
20. Channel inputs: Line and phono signal inputs. Line inputs are used to connect to
line level sources such as CD players, samplers, tape players, etc. Phono
inputs are used to connect to turntables. Master output connects to an ampli-
fier, EQ, crossover, or other outboard signal processing. Record out connects
to tape recorder, mini disk recorder, etc.
21. Outputs: Rec and unbalanced master outputs.
TE C H N I C A L S P E C I FI C AT I O N S
Line inputs:
2
(RCA),
150
mV /
27
K ohm
Phono inputs:
2
(RCA),
3
mV /
47
K ohm
Master output:
1
(1/4” TRS Balanced/RCA unbalanced),
775
mV /
1K
ohm
Record output:
1
(RCA),
245
mV /
10
K ohm
Headphone output:
1
(1/4 inch),
32
-
200
ohms recommended
Frequency Response:
20
Hz -
20
kHz, +/-
2
dB
Tone Control :
+
9/-26
dB (Hi, Low)
Gain Control:
0-20dB
S/N Ratio:
Less than 70dB
T.H.D:
less than
0.2%
Dimension(LxWxD):
13
6/8
” x
7
2/8
”
x
4
” (
350
x
184
x
102
mm)
Weight:
7
lbs (
3.2
Kg)
WA R R A N T Y
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of twelve
(12) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N TY TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N TY REGIST R ATION FORM FOUND AT
W W W. STA N TO N M AG N E TI CS . CO M
2821 Evans Street • Hollywood, FL 33020
FU N C TI O N S ( c o n t ’d )
S P E C I A L P R OTE K TI O N
Your SK ONE comes with a special PROTEKT™ aluminum panel designed to
make the surface of the mixer is as smooth as possible while still enabling you
to field-replace key components. The PROTEKT™ panel covers all screws that
may get in the way of your performance. You can still easily remove the front
panel to replace any of the modular parts which are subject to wear and tear:
crossfader, input faders and input toggle switches.
