EN
D
F
I
E
P
NL
N
S
DK
FIN
RUS
PL
GR
H
CZ
SK
LT
EST
LV
RO
BG
13
Stanley TLM 220i 773938a en
Functions
Indirect Measurement - determining a distance using 3
measurements
See figure {
Q
}
Press this button
twice
; the display shows the following symbol
.
The laser is switched on.
Aim at the upper point (1) and trigger the measurement. After the
first measurement the value is adopted. Keep the instrument as horizontal
as possible
Press and hold down this button to trigger continuous measurement
, sweep the laser up and down over the ideal target point.
Press to stop continuous measurement (2). The value is adopted. Aim
at the lower point and
press this button to trigger the measurement (3)
. The result is
displayed in the summary line, the partial results in the secondary lines.
Press and
hold
the
key to display additional information about for
example the partial distances
,
and the minimum distance
.
Indirect measurement - determining a partial value using
3 measurements
See figure {
R
}
e.g. determining the height between point 1 and point 2 using three target
points.
Press this button
three times
; the display shows the following
symbol
. The laser is switched on.
Aim at the upper point (1).
Press this button and trigger the measurement
. After the first
measurement the value is adopted.
Triggers the measurement
. After the second measurement the
value is adopted.
Press and hold down this button to trigger continuous measurement
. Sweep the laser up and down over the ideal target point.
Press this button to end continuous measurement. The result is
displayed in the summary line, the partial results in the secondary lines.
Press and
keep pressed
the
key to display additional information
about the measurement of the partial lengths
and
.
Storage of constants / historical storage
Storage of a constant
You can store and recall a frequently used value e.g. height of a room.
Measure the desired distance, press and hold the
button until the
device beeps to confirm storage.
Recalling the constant
Press this button
twice
to recall the constant and then press the
button to enter it into your calculation.
Historical storage
Press this button
once
and the previous 20 results (measurements
or calculated results) are shown in reverse order.
The
and
buttons can be used for navigation.
Press this button to use a result from the summary line for further
calculations.
Pressing the
and
buttons at the same time erases all the values
in historical storage.
Summary of Contents for TLM 220
