LOCATION
When choosing a location for this appliance you must
have the following:
A. Sufficient room for installation and servicing.
B. Adequate clearance to combustibles (see sec-
tion Clearance to Combustibles).
C. A satisfactory flue system (See Flue Systems).
D. Fixed fuel supply line and shut off valve
(See Fuel Supply).
E. Adequate air supply to support combustion (See
Ventilation & Combustion Air Requirements).
F. Proper fused power point (See Electrical
Supply).
G. Allow for adequate air circulation around stove.
H. Solid floor or base of non-combustible material
which is capable of supporting the total weight of
the stove. (See Hearth Construction).
I. Position in the area to be heated - central
locations are usually best.
J. Avoid installing the stove near door ways,
windows, walkways and areas with air
stream passing through.
NOTE:
When passing through walls or ceilings
with the flue system:
K. Always check for obstructions for example
electrical fittings, wiring, ducting, plumbing
and fixed furnishings.
HEARTH CONSTRUCTION
When a non-combustible floor surface is not available
then the cooker must be placed on other insulating
material. We recommend a slab of precast concrete
40mm (1
1/2
) inches deep. If other insulating material
is being used, the dimensions of the slab of this in-
sulating material must afford similar protection. This
hearth must extend 300mm (12 inches) to either side
of the appliances and 300mm (12 inches) to the front.
Note:
The hearth must be level, stable and capable
of supporting the stove.
ELECTRICAL SUPPLY
All wiring external to the appliance must conform to
the current B.S. 7671 (UK) B.S.7462 Safety Docu-
ment 635: ETC Part 1 Section 5.4.6 & The Electricity
at Work Regulations.
The stove requires a 220 V - 240 V 50Hz supply.
Connection of the appliance and any system controls
to the mains supply must be through a moulded on
plug top which is fitted to the appliance in accordance
with EN 60335 and Consumer Protection S.I. 1994
No. 1768 Plug and Sockets (Safety) Regulations
1998.
NOTE:
Always install in accordance with current local
wiring regulations.
WARNING:
THIS SUPPLY MUST BE EARTHED
(Refer to B.S. 7430: Code of Practice for Earthing).
IMPORTANT:
The appliance plug must be accessi-
ble and so, must not be obstructed and close to the
stove. To isolate the stove, completely unplug from
the mains socket. Persons in charge of this stove
should be aware of this socket outlet position.
5
Fig.1
INSTALLATION
The installation must be completed in accordance with current National and European Standards and Local
Codes. It should be noted that the requirements and these publications may be superceded during the life of
this manual.
B.S. 5410 Part 1 Oil Installations
The Building Regulations:
Part J England, Wales.
Part F Section III Scotland
Part L Northern Ireland
Part J Ireland
The Control of Pollution (Oil) Regulations:
B.S. 7671: Requirements for Electrical Regulations
Safety Document 635: The Electricity at Work Regulations.
Safety, Health and Welfare at Work Act for Ireland, England, Wales and Scotland.
