10
11
(Original instructions)
© 2017 English
(Original instructions)
© 2017 English
EN
3.1.14
W
arning
.
NEVER move the appliance by pulling on the POWER CABLE.
3.1.15
W
arning
.
The use of non-original accessories and any other accessories not specifically intended
for the model in question is prohibited. All modifications to the appliance are prohibited. Any
modifications made to the appliance shall render the Declaration of Conformity null and void and
relieve the manufacturer of all liability under civil and criminal law.
3.2
SAFETY “MUSTS”
3.2.1
W
arning
.
All electrical conductors MUST BE PROTECTED from jets or splashes of water.
3.2.2
W
arning
.
The electric supply connection must be made by a qualified electrician and comply with
IEC 60364-1. Either a residual current device that will cut off the power supply if the leakage current
to earth exceeds 30 mA for 30 ms or a ground fault interrupt device must be installed.
3.2.3
W
arning
.
DURING start-up, the appliance may generate interference on the electrical system.
3.2.4
W
arning
.
Use only approved electrical extension leads with suitable conductor cross-section.
3.2.5
W
arning
.
Always turn off the switch when leaving the appliance unattended.
3.2.6
W
arning
.
The air flow may cause parts to rebound: wear all the protective clothing and equipment
(PPE) needed to ensure the operator’s safety.
3.2.7
W
arning
.
Switch the appliance off and disconnect it from the power source before any assembly,
maintenance, storage and transport operations.
3.2.8
W
arning
.
Maintenance and/or repair of electrical components MUST be carried out by qualified staff.
3.2.9
W
arning
.
Before each use, and periodically, CHECK that screws are tight and all appliance
components are in good condition; inspect for broken or worn parts.
3.2.10
W
arning
.
To ensure the appliance’s safety, only use the manufacturer’s genuine parts, or other parts
which carry its approval.
3.2.11
W
arning
.
Unsuitable extension cords can be dangerous. If an extension cable is used, it must be
suitable for outdoor use, and the connection must be kept dry and off the ground. Use of a power
cable reel which keeps the socket at least 60 mm above the ground is strongly recommended.
Summary of Contents for SXVC20TPE
