14
15
RECOMMENDATIONS
If painted surfaces are peeling or chipping, use extreme
caution as pressure washer may remove the loose paint
from the surface. Note: Always pre-test any paint work in an
inconspicuous area in case of paint damage.
DECK CLEANING - WITH OR WITHOUT DETERGENT
Pre-rinse deck and surrounding area with fresh water. If using
deck wash, place deck wash into a bucket of cold water and
apply with a brush and thoroughly clean area.
For best results, limit your work area to smaller sections of
approximately 2m square, allow deck wash to remain on surface
1-3 minutes.
Do not allow deck wash to dry on surface, if surface appears to
be drying, simply wet down surface with fresh water.
Rinse at high pressure in a long sweeping motion keeping the
spray nozzle approximately 75mm to 150mm from the cleaning
surface. Always clean from top to bottom and from left to right.
For stubborn dirt/stains you can use the turbo nozzle. Be careful
as the turbo nozzle may damage timber or some surfaces if held
too close or too long on the area.
When moving on to a new section of the cleaning surface, be
sure to overlap the previous section to eliminate stop marks and
ensure a more even cleaning result.
HOUSE SIDING - WITH OR WITHOUT DETERGENT
Pre-rinse cleaning surface with fresh water. If using house
wash, place house wash into a bucket of cold water and apply
with a brush and thoroughly clean area. For best results apply
house wash from bottom to top and limit your work area to
smaller sections of approximately 2m square, allow house wash
to remain on surface 1-3 minutes.
Do not allow house wash to dry on surface, if surface appears
to be drying, simply wet down surface with fresh water.
Rinse at high pressure from top to bottom in an even sweeping
motion keeping the spray nozzle approximately 150mm from the
cleaning surface.
CEMENT PATIOS, BRICK & STONE - WITH OR
WITHOUT DETERGENT
Pre-rinse cleaning surface with fresh water. If using all
purpose cleaner, place all purpose cleaner into a bucket of
cold water and apply with a brush and thoroughly clean area.
For best results, limit your work area to smaller sections of
approximately 2m
2
. Allow all purpose cleaner to remain on
surface 1-3 minutes.
Do not allow all purpose cleaner to dry on surface, if surface
appears to be drying, simply wet down surface with fresh water.
Rinse at high pressure in a sweeping motion keeping the spray
nozzle approximately 75mm to 150mm from the cleaning surface.
CLEANING TIPS
Always clean from top to bottom and from left to right. For
stubborn dirt/stains you can use the turbo nozzle. Be careful as
the turbo nozzle may damage timber or some surfaces if held
too close or too long on the area.
CARS, BOATS & MOTORCYCLES - WITH OR WITHOUT
DETERGENT
Pre-rinse vehicle with fresh water. If using vehicle wash, place
vehicle wash into a bucket of cold water and apply with a soft
sponge or cloth and thoroughly clean area. For best results,
limit your work area to smaller sections of approximately 2m
2
.
Allow vehicle wash to remain on surface 1-3 minutes. For best
results, clean one side of vehicle at a time and always apply
vehicle wash from bottom to top, do not allow vehicle wash to
dry on surface. Rinse at high pressure in a sweeping motion
keeping the spray nozzle approximately 150mm to 200mm from
the cleaning surface (distance should increase with pin-striping,
decals or other sensitive surfaces).
Always clean from top to bottom and from left to right. For best
results, wipe surface dry with a chamois or soft dry cloth.
BBQ GRILLS, OUTDOOR POWER EQUIPMENT &
GARDENING TOOLS - WITH OR WITHOUT DETERGENT
Pre-rinse surface with fresh water. If using all purpose cleaner,
place all purpose cleaner into a bucket of cold water and apply
with a brush and thoroughly clean area. For best results, limit
your work area to smaller sections of approximately 2m
2
. Allow
all purpose cleaner to remain on surface 1-3 minutes.
Do not allow all purpose cleaner to dry on surface, if surface
appears to be drying, simply wet down surface with fresh water.
Rinse at high pressure keeping the spray nozzle approximately
75mm to 150mm from the cleaning surface. For removing
extremely stubborn dirt, it may be necessary to move the spray
nozzle even closer to the surface for greater dirt cutting action
or you can use the turbo nozzle. Be careful as the turbo nozzle
may damage timber or some surfaces, including chipped paint if
held too close or too long on the area. To remove caked-on mud
from garbage cans, lawn mower blades, wheelbarrows or other
non-sensitive metal surfaces.
PATIO & LAWN FURNITURE - WITH OR WITHOUT
DETERGENT
Pre-rinse surface with fresh water. If using all purpose cleaner,
place all purpose cleaner into a bucket of cold water and apply
with a brush and thoroughly clean area. For best results, limit
your work area to smaller sections of approximately 2m
2
. Allow
all purpose cleaner to remain on surface 1-3 minutes.
Do not allow all purpose cleaner to dry on surface, if surface
appears to be drying, simply wet down surface with fresh water.
Rinse at high pressure keeping the spray nozzle approximately
75mm to 150mm from the cleaning surface. For stubborn dirt/
stains you can use the turbo nozzle. Be careful as the turbo
nozzle may damage timber or some surfaces, including chipped
paint if held too close or too long on the area.
