29
INSTALLATION
Check the appliance is electrically safe when you have finished.
Final Fitting
Fitting the 2-piece Plinth
Fit the inner plinth to the bottom front of the cooker using
the 5 screws provided (3x M5 screws in the lower edge, 2x
No.8 screws in the each end)
(Fig. 7-13)
.
Loosen the 2 screws in the front of the inner plinth.
Locate the 2 slotted brackets on the inside of the outer plinth
onto the 2 screws
(Fig. 7-14)
.
Note:
To aid the fitting of the outer plinth, we advise that you
open the doors and place the wings of the outer plinth over
the side panels at approximately a 45º angle
(Fig. 7-15)
. This
will aid location of the outer plinth onto the retaining screws.
Using a suitable screwdriver through the slots in the outer
plinth, tighten the 2 screws to secure.
The height of the outer plinth can be adjusted by loosening
the 2 retaining screws and sliding it up or down to suit and
then retightening the screws.
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer:
Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
M5 (large screw)
No.8 (smaller screw)
Inner plinth
Fig. 7-13
Outer plinth
Inner plinth
Fig. 7-14
Outer plinth wing
Side panel
Fig. 7-15
Summary of Contents for Supreme Deluxe 90 Induction
Page 1: ...Supreme Deluxe 900 Induction User Guide Installation Service Instructions U110464 01 ...
Page 2: ......
Page 4: ...iv ...
Page 39: ...35 Notes ...
