Stanley STPW1400, Instruction Manual

Page: 6 / 14

5
ENGLISH
@
WARNING!
Warning: Do not use this appliance without
reading this instruction sheets.
- The electric supply connection shall be made
by a qualified electrician and comply with
IEC60364-1.
- The Electric supply to this appliance should
include either a residual current device that will
interrupt the supply if the leakage current to
earth exceeds 30 mA for 30 ms or a device that
will interrupt the earth circuit.
- WARNING: This appliance has been designed
for use with the cleaning agent supplied or
recommended by the manufacturer. The use
of other cleaning agents or chemicals may
adversely affect the safety of the appliance.
-
WARNING:
Do not use the appliance within
range of persons unless they wear protective
clothing.
- WARNING: High pressure jets can be
dangerous if subject to misuse. The jet must not
be directed at persons, live electrical equipment
or the appliance itself.
- Do not direct the jet against yourself or others in
order to clean clothes or foot-wear.
- Risk of explosion
- Do not spray flammable liquids.
- Disconnect from the electrical power supply
before carrying out user maintenance .
- High pressure cleaners shall not be used by
children or untrained personnel.
- To ensure appliance safety, use only original
spare parts from the manufacturer or approved
by the manufacturer.
-
WARNING:
Water that has flown through
backflow preventers is considered to be non-
potable.
- WARNING: The machine shall be disconnected
from its power source during cleaning or
maintenance and when replacing parts for mains
operated machines by removing the plug from
the socket-outlet;
- WARNING: High pressure hoses, fittings
and couplings are important for safety of the
appliance. Use only hoses, fittings and couplings
recommended by the manufacturer.
- Do not use the appliance if a supply cord or
important parts of the appliance are damaged,
e.g. safety devices, high pressure hoses, trigger
gun.
- WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
- WARNING: Inadequate extension cords can be
dangerous.
_ This high pressure washer must not be used at
temperatures below 0°C.
@
WARNING!
- Cord on drums should always be completely
unwinded to prevent the cord from overheating.
- If an extension cord is used, the plug and socket
must be of watertight construction.
- Inadequate extension cords can be dangerous.
- comply with the below-mentioned
requirements for length and cord dimensions.
1.0
mm²
max. 12.5 m
1.5
mm²
max. 20 m
2.5
mm²
max. 30 m
Power cord connections should be kept dry and
off the ground.
If the power cord is damaged, it must be replaced
by the manufacturer or his service agent or similarly
qualified person in order to avoid a hazard.
All keep the machine on a stable and flat surface
during operation, handling, transportation and
storage. Sudden overturn of machine will cause
injury to body.
In the event of accident or breakdown, switch
off the machine immediately. (e.g. contact with
detergent: rinse with an abundance of clean water)
@
ATTENTION!
Through poor conditions of the electrical MAINS,
shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment
(eg. Blinking of a lamp). If the MAINS-IMPEDANCE
Zmax < 0.335 OHM, such disturbances are not
expected. (In case of need, you may contact you
local supply authority for further information.)
WARNING! ELECTRICAL SHOCK HAZARD
Improper connection of the equipment-
grounding conductor can result in a risk
of electrical shock. Check with a qualified
electrician or service person if you are unsure
if an outlet is properly grounded. DO NOT
modify the plug provided with the appliance to
fit an outlet, have a proper outlet installed by a
qualified electrician.
MAINS POWER CONNECTION
The following should be observed when
connecting the high pressure washer
to the electric installation:
- The electric installation shall be made by a