Stanley STHR202, Original Instructions Manual

Page: 8 / 28

8
ENGLISH
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY product needs
replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for raw
materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
STANLEY provides a facility for the collection and recycling
of STANLEY products once they have reached the end of
their working life. To take advantage of this service please
return your product to any authorised repair agent who will
collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local STANLEY office at the
address indicated in this manual. Alternatively, a list of
authorised STANLEY repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
(Original instructions)
Replace the carbon brush (Fig. D)
Lubrication
• Regularly replace and inspect the carbon brush. Once
completely worn out by continuous wear and tear, it will
have to be replaced. Must keep carbon brush clean and
sliding freely within the brush holder. Both carbon
brushes have to be replaced at the same time.
• Remove the fixed screws (9) on the carbon brush to
remove the carbon brush (10) and brush holder.
• Remove the coil spring supporting the carbon brush (11)
in the brush holder, and insert a new carbon brush that
meets the specifications.
• Set up the brush holder again and return the supporting
coil spring to its original position.
Cleaning
Warning! Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust mask when
performing this procedure.
Warning! Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the
material of the parts. Use only mild soap and damp cloth to
clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into liquid.