background image

NEVER LEAVE A FAN  UNATTENDED WHILE 

OPERATING OR WHILE CONNECTED TO A 

POWER SOURCE 

© 2016 Obelis S.A Registered Address:

Bd. Général Wahis, 53, 1030 Brussels, Belgium

STANLEY, The STANLEY Logo, The Notched Rectangle and the Yellow and Black Diagonal Package 

Design are all trademarks of Stanley Black & Decker, Inc. or an affiliate thereof.

To reduce risk of fire and to properly exhaust air, be sure to duct air outside.

CAUTION

Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces or garages.

Do not operate any fan with a damaged cord or plug.

WARNING

Discard fan or return to an authorized service facility for examination and/or repair.
Do not run under carpeting.
Do not cover with throw rugs, runners, or similar coverings.
Do not route cord under furniture or appliances.
Arrange cord away from traffic area where it will not be tripped over.
To reduce the risk of electric shock, do not expose to water/rain or use in damp locations.

IMPORTANT:  

READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY,  SERVICE OR 

USE OF THIS FAN.  FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN  

SERIOUS PERSONAL INJURY AND / OR PROPERTY DAMAGE.

THIS IS A FAN - NOT A TOY! TO REDUCE THE RISK OF PERSONAL INJURY 

AND ELECTRIC SHOCK, FANS SHOULD NOT BE PLAYED WITH OR PLACED 

WHERE SMALL CHILDREN CAN REACH IT.

WARNING

 To guard against electric shock while operating, do not allow fan to come in contact 

with other grounded objects such as pipes, radiators, etc.

WARNING

Risk of fire, electric shock, or personal injury when performing service or mainte-

nance.  Unplug or disconnect the fan from the power supply before servicing.

WARNING

CAUTION Automatically Operated Device - To Reduce The Risk Of Injury 

Disconnect From Power Source Before Servicing

WARNING

To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid- 

State Speed Control Device.

WARNING

To Reduce The Risk Of Electric Shock And Injury To Persons, Do Not Use In a 

Window.

WARNING

To Reduce The Risk Of Electric Shock, Do Not Expose To Water Or Rain or us in 

damp locations.

WARNING

Safety Information

Summary of Contents for ST-20F-DDF-E











Reviews: