16
jewellery, which can be caught in moving
parts. Use of sturdy gloves, non-skid footwear and
safety glasses is recommended.
5. Use extra care when handling fuels. They are
flammable and the vapours are explosive.
The following points should be observed.
- Use only an approved container.
- Never remove the fuel tank cap or add fuel with
the power source running. Allow engine and
exhaust components to cool down before
refuelling.
- Do not smoke. when operating fueling or starting
this machine .
- Never refuel indoors or in confirmed spaces.
- Never store the product or fuel container inside
where there is an open flame, such as near
a water heater.
- If fuel is spilled, do not attempt to start the
product, but move it away from the area of
spillage before starting.
- Always replace and securely tighten the fuel tank
cap after refuelling.
- Drain fuel outdoors only.
6. If the cutting mechanism strikes any foreign
object or the product starts making any unusual
noise or vibration, shut off the power source and
allow the product to stop. Disconnect the
spark plug wire from the spark plug and take the
following steps:
- Inspect for damage.
- Check for, and tighten, any loose parts.
- Have any damaged parts replaced or repaired
with parts having equivalent specifications.
7.Wear ear protection!
Part list
A. Main unit
1. Front cover
2. Spark plug connector
3. Choke lever
4. Primer
5. Air filter case
6. Fuel tank cap
7. Recoil starter handle
8. Harness
9. Hip protection
10. Securing clip
11. Step guard
12. Clamp
13. Locking pin
14. Locking knob
15. Auxiliary handle
16. Control unit
17. Handle grip
18. Throttle trigger
19. Ignition switch on/off
20. Throttle interlock
21. Pole extension
B. Pruner attachment
1. Chain oil tank cap
2. Cover
3. Locking nut
4. Spring washer
5. Pivot
6. Saw Chain
7. Guide bar
8. Locking lever
9. Clutch
10. Drive sprocket
11. Tension pin
12. Tension screw
13. Bolt
14. Oiling port
15. Guide bar cover
16. Pruner shaft
C. Tools
C1.:Socket wrench
C2: Screw driver
C3: Hex key 4 mm
C4:Spark plug wrench
C5: Mixing bottle
ASSEMBLY INSTRUCTIONS
WARNING!
Be careful with small parts that
are removed during assembly or when
making adjustments. Make sure you do not
lose them.
G
B
Summary of Contents for SPS-750
