Stanley SPS-1400, Original Instructions Manual

Page: 21 / 119

21
Overview of Tool Components (A1)(B1)
1. Main shaft
2. Handlebar
3. Operating handle
4. Operating switch
5. Locking device
6. Throttle lever
7. Suspension Harness
8. Exhaust pipe guard
9. Engine
10. Fuel tank
11. Cutting blade
12. Cutting guard
13. Trimmer head
Problem Possible C ause Trouble shooting
The engine stops. Incorrect adjustment of carburetor Have the carburetor adjusted by a
technician.
The tool starts, but the
engine has little power.
Incorrect adjustment of choke lever
Air filter is dirty
Incorrect adjustment of carburetor
Switch to
Remove the filter made of foamed
plastic, wash in soapy water and
reinsert when dry.
Have the carburetor adjusted by a
technician.
The tool does not start, or
starts, but does not run.
Incorrect procedure when starting
Incorrect adjustment of carburetor
Spark plug is full of soot
Gasoline filter plugged up
Observe the instructions in “Starting
when Engine is Cold 1-8”.
Have the carburetor adjusted by a
technician.
Clean the spark plug, correct the air
gap, or replace the spark plug.
Replace gasoline filter
Engine runs irregularly. Incorrect air gap at spark plug
Spark plug burnt down
Clean the spark plug, correct the air
gap, ideal is 0,25"/0.63 mm, or replace
the spark plug.
Excessive emission of
smoke.
Incorrect air gap at spark plug
Spark plug burnt down
Have the carburetor adjusted by a
technician.
Empty the tank, fill in the correct
mix: 2-stroke mix 40:1.
14. Allen key
15. Spark plug wrench
16. Gasoline Blending tank
17. Carrying strap
18. Locking button
19. Locking screw
20. Retention pin
21. Cutting line
22. Bracket base
23. Rotatable bracket
24. Bigger spring
25. Smaller spring
26. Bracket cover
27. Handle screw
G
B