Materials Required
• MyCall
®
Communicator
™
tag (p/n 806A5601)—
includes battery (installed).
• MyCall Communicator tag fasteners. One of the fol-
lowing is required:
• Neck chain or cord to wear around the neck.
• Strap clips to clip Communicator tags to clothing.
• Emergency Release Clip Set (p/n 805A3001) to
fasten Communicator tags with a breakaway Panic
alarm feature. Set includes 12 Release Clips (12
Alarm Clips and 12 Alarm Keys).
User Considerations
• Wear the Communicator tag in full view.
• The tag must remain visible in order to receive Beacon
location transmissions. Do not cover the front of the
tag when wearing it, or place it in a shirt or pants
pocket.
• Point the bulge outward to maximize the reception of
Beacon location marker transmissions.
• Do not place the Communicator tag where it could
be bumped or damaged.
• If using the Emergency Release Clip, ensure the break-
away chain or cords do not break before pulling the
Alarm Key out of the Alarm Clip.
Panic Alarm Feature
To call for help at any time, simply press the top or bottom
button on the Communicator tag. As an option, the tag
can be confi gured to emit a series of short beeps each
time it is pressed.
Wearing the Communicator Tag
Communicator tags can be worn in three different ways:
around the neck like a pendant, clipped to a person’s
clothes, or fastened securely to a person’s clothes to cause
a Panic alarm if automatically pulled off.
1
Turn the Communicator tag on.
The MyCall Communicator tag ships from the factory
in a “sleep” mode to minimize battery consumption.
Press either Communicator tag button to turn the
Communicator tag on. The Communicator tag emits
a short beep.
2
Test the Communicator tag.
Before installing the Communicator tag, check that
it is operating properly. Turn on Tag Diagnostics in
the MyCall system software, and then initiate a Panic
alarm. Check the software to make sure that the alarm
message has been received.
3
Fasten the Communicator tag.
Installation differs depending upon the fastener used.
A
Fastened to a neck chain or cord
Slip the neck chain or cord through the loop
located on the top of the Communicator tag. Use
a standard or breakaway chain or cord, as required.
Part Number
806A5601
MyCall® Communicator™ Tag User Guide
309 Legget Drive Ottawa, ON K2K 3A3 Canada
Telephone
: 1.866.559.6275
International
: +1 (613) 592.6997
Facsimile
: (613) 592.4296
Web site
: www.stanleyhealthcare.com
© 2005 - 2010 XMARK Corporation. All Rights Reserved.
Printed in Canada. September 2010. 806U5401 Rev 03.
