background image

4

5

• All ON/OFF switches should be in the OFF position when the unit is charging or not in use. Make sure all switches are in the OFF 

position before connection to a power source or load.

WARNING: SHOCK HAZARD

• 

Do not operate charger with damaged cord or plug

.

• 

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way

.

• 

Do not disassemble charger; 

return it to the manufacturer when service or repair is required. Incorrect reassembly may result 

in a risk of electric shock or fire.

• 

Outdoor use extension cords. 

When appliance is used outdoors, use only extension cords intended for use outdoors and so marked.

• 

Extension cords. 

Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy 

enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power 

and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in 

doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.

MINIMUM GAGE FOR CORD SETS

Volts  

Total Length of Cord in Feet

120V 

0-25  26-50  51-100 101-150 

 

(0-7.6m)  (7.6-15.2m)  (15.2-30.4m) (30.4-45.7m)

240V 

0-50 

 51-100 

101-200 

201-300

 

(0-15.2m)  (15.2-30.4m)  (30.4-60.9m) (60.9-91.4m)

Ampere Rating 

Extension Cord Length

More 

Not more  

0’-25’ 

26’-50’ 

51 ’-100 ’  

101’ -150 ’

Than 

Than 

American Wire Gage (AWG)

 

 

18 16 16 14

 

10 

18 16 14 12 

10 

12 

16 16 14 12

12 - 

16 

14 

12 

Not Recommended

When an extension cord is used,

 make sure that:

•  a) the pins of extension cord are the same number, size and shape as those in the charger,

•  b) the extension cord is properly wired and in good electrical condition,

•  c) the wire size is large enough for the AC rating of the charger.

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: 

Pull cord by plug rather than cord when disconnecting 

the extension cord from the unit or the outlet.

SPECIFIC SAFETY INSTRUCTIONS FOR COMPRESSORS

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: 

Never leave the compressor unattended while in use.

WARNING: BURST HAZARD:

• Carefully follow instructions on articles to be inflated.

• Never exceed the recommended pressure listed in instructions on articles to be inflated. If no pressure is given, contact article 

manufacturer before inflating. 

• Monitor the pressure at all times on the pressure gage.

CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:

Do not operate compressor continuously for longer than approximately 10 minutes, depending on ambient temperatures, as it may 

overheat. In such event, compressor may automatically shut down. Turn off the Compressor Power Switch immediately and restart 

after a cooling down period of approximately 30 minutes.

SPECIFIC SAFETY INSTRUCTIONS FOR JUMP STARTERS

WARNING: BURST HAZARD

Do not use the unit for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and 

cause injury to persons and damage property. Use the unit for charging/boosting a lead-acid battery only. It is not intended to 

supply power to a low-voltage electrical system other than in a starter-motor application.

• Use of an attachment not supplied, recommended or sold by manufacturer specifically for use with this unit may result in a risk of 

electrical shock and injury to persons.

WARNING: RISK OF EXPLOSIVE GASES

• Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal battery operation. 

For this reason, it is of the utmost importance that each time before using the jump-starter you read this manual and follow 

instructions exactly.

SAFETY GUIDELINES / DEFINITIONS

DANGER: 

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING: 

Indicates a potentially hazardous situation which, if not  avoided, could result in death or serious injury.

CAUTION:

 Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

CAUTION:

 Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in 

property damage.

RISK OF UNSAFE OPERATION.

 When using tools or equipment, basic safety precautions should always be followed to reduce the 

risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and 

property damage. There are certain applications for which tools and equipment are designed. Manufacturer strongly recommends 

that this product NOT be modified and/or used for any application other than for which it was designed. Read and understand all 

warnings and operating instructions before using any tool or equipment.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS

WARNING: Read all instructions before operating jump-starter. Failure to follow all instructions listed below may 

result in electric shock, fire and/or serious injury.

GENERAL SAFETY WARNINGS AND INSTRUCTIONS

WARNING: 

This product or its power cord contains lead, a chemical known to the State of California to cause cancer and birth 

defect or other reproductive harm. Wash hands after handling.

• 

This unit was designed for household use only.

WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, BURST HAZARD, OR INJURY TO PERSONS OR PROPERTY:

• 

Avoid dangerous environments. 

Don’t use appliances in damp or wet locations. Don’t use appliances in the rain.

• 

Keep children away. 

All visitors should be kept at a distance from work area.

• 

Dress properly.

 Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and substantial, non-

skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair.

• 

Use safety glasses and other safety equipment.

 Use safety goggles or safety glasses with side shields, complying with 

applicable safety standards. Safety glasses or the like are available at extra cost at your local dealer.

• 

Store indoors. 

When not in use, this equipment should be stored indoors in a dry, and high or locked-up place – out of reach of 

children.

• 

Don’t abuse cord. 

Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp 

edges.

• 

Disconnect appliances. 

Disconnect the appliance from the power supply when not in use, before servicing, and when changing 

accessories.

• 

Ground Fault Circuit Interrupter (GFCI) protection

 should be provided on the circuits or outlets to be used. Receptacles are 

available having built in GFCI protection and may be used for this measure of safety.

• 

Use of accessories and attachments. 

The use of any accessory or attachment not recommended for use with this appliance 

could be hazardous. Refer to the accessory section of this manual for further details.

• 

Stay alert.

 Use common sense. Do not operate appliance when you are tired or impaired.

• 

Check for damaged parts.

 Any part that is damaged should be replaced by the manufacturer before further use. Contact the 

manufacturer at (877) 571-2391 for more information.

• 

Do not operate this appliance near flammable liquids or in gaseous or explosive atmospheres. 

Motors in these tools 

normally spark, and the sparks might ignite fumes.

• 

Never submerge this unit in water or any other liquid;

 do not expose it to rain, snow or use when wet.

• 

To reduce risk of electric shock,

 disconnect the unit from any power source before attempting maintenance or cleaning. 

Turning off controls without disconnecting will not greduce this risk.

• 

This equipment employs parts (switches, relays, etc.) that produce arcs or sparks. 

Therefore, if used in a garage or 

enclosed area, the unit MUST be placed not less than 18 inches above the floor.

• 

Do not use this unit to operate appliances that need more than 5 amps to operate from the 12 volt DC accessory 

outlet.

• 

Do not insert foreign objects into either the USB outlet or the 12 volt DC accessory outlet.

SPECIFIC SAFETY INSTRUCTIONS FOR CHARGING THIS UNIT

• 

IMPORTANT: 

This unit is delivered in a partially charged state. Fully charge unit with a household extension cord (not supplied) 

for a full 40 hours before using for the first time. You cannot overcharge the unit using the AC charging method.

• To recharge this unit, use only the built-in AC Charger.

JS900CS_ManualENSP_022514.indd   4-5

2/25/2014   10:46:56 AM

Summary of Contents for JS900CS











Reviews: