SP5 • 7
5.
Start at step 1 again and re-check your adjustments. If the three laser
dots stay on the same mark, then calibration is complete.
6.
Push on the calibration port covers.
Your SP5 is calibrated and ready to go.
SAFETY AND CERTIFICATIONS
Working safely with this instrument is possible only when the operating and
safety information are read completely and the instructions contained there-
in are strictly followed.
Do not
remove the label on the side of the housing.
The use in combination with other optical instruments, manipulations or use
in other applications other than described here, can lead to dangerous laser
outputs.
Do not
stare into the laser beam.
Do not
direct the laser beam at other persons. Since the laser beam is of the
boundled type, check the beam path over a relatively long distance and take
the necessary precautions.
This laser complies with all applicable portions of title 21 of the Code of
Federal Regulations set by the Dept. of Health, Education, and
Welfare, the Food and Drug Administration, the Center for Devices, and the
Bureau of Radiological Health.
The SP5 has also been tested and complies with the CE certification require-
ments set forth in the EC regulations 89/336/EEC and EN 61000-6-1 (EN50082-
1), EN 61000-6-3 (EN50081-1) and IEC 60-825-1.
Summary of Contents for FatMaxSP5
Page 2: ...2 SP5 1 2 4 1 3 2 Fig A Fig C Fig B ...
Page 26: ...Fig D Fig E Fig F Fig G 26 SP5 ...
Page 27: ...SP5 27 ...
