Stanley FATMAX SFMCMW2653 Original Instructions Manual Download Page 16

Page: 16 / 156

English

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails to
produce sufficient power on jobs which were easily done before.
At the end of its technical life, discard it with due care for our
environment:
• Run the battery pack down completely, then remove it from

the tool.

• Li-Ion cells are recyclable. Take them to your dealer or a

local recycling station. The collected battery packs will be
recycled or disposed of properly.

Guarantee

1 Year Guarantee

All STANLEY FATMAX power tool products include a 1 year
guarantee as standard. In the unlikely event that your powertool
becomes defective due to faulty materials or worksmanship
within 1 year of purchase, STANLEY guarantees to replace or
repair all defective parts free of charge, or – at our discretion –
replace the item free of charge.

3 Year Guarantee

Register your STANLEY FATMAX power tool within 4 weeks
of purchase and qualify for an additional 2 year guarantee.
Having registered your power tool, in the unlikely event that
your powertool becomes defective due to faulty materials or
worksmanship, STANLEY guarantees to replace or repair all
defective parts free of charge, or – at our discretion – replace the
item free of charge.

TROUBLESHOOTING

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local STANLEY FATMAX repair agent.

WARNING:

Before proceeding, release the bail bar to turn

mower off and wait for the blade to stop.

Problem

Possible solution

Mower doesn’t run
when bail handle
is activated

Check to make sure mower battery is properly
installed and that the button on switch box is
being completely depressed before pulling the
bail handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over and
check that blade is free to turn.
Check that the battery cavity is free of debris and is
connected properly.
Has battery been fully charged? Press state of
charge button.

Motor stops
while mowing

Release bail handle to turn mower off. Remove
safety key and battery pack Turn mower over and
check that blade is free to turn.
Raise cutting height of wheels to highest position
and start mower.
Check that the battery cavity is free of debris and is
connected properly
Has battery been fully charged? Press state of
charge button
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.

Mower runs but
cutting performance
is unsatisfactory

Release bail handle to turn mower off. Uninstall
power source. Turn mower over and check:
• Blade for sharpness - Keep blade sharp.
• Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.

Mower is too hard
to push

Release bail handle to turn mower off. Uninstall
power source. Raise cutting height to reduce deck
drag on grass. Check each wheel for free rotation.

Mower is abnormally
noisy and vibrates

Release bail handle to turn mower off. Uninstall
power source. Turn mower on side and check blade
to ensure it has not been bent or damaged. If blade
is damaged, replace with a STANLEY FATMAX
replacement blade. If the underside of the deck is
damaged, return mower to a STANLEY FATMAX
Authorised service centre.
If there is no visible damage to the blade and the
mower still vibrates:
•  Release bail handle to turn mower off.
•  Unplug mower.
•   Disassemble entire blade assembly as

described in the

Removing and installing

blade

section.

• Remove any debris and clean each piece.
• Replace each piece as described in the

Removing and installing blade

section.

If mower still vibrates, return the mower to an
authorised STANLEY FATMAX service center.